Author Topic: What's wrong here?  (Read 230 times)

  • Offline Pete

  • Posts: 5,014
  • Hero Member
What's wrong here?
on: January 28, 2012, 17:35:30 PM
PC is plugged into a switch via a cat5 cable, says 'network cable disconnected.'

I try the cable with my laptop and it works fine, I get a DHCP address and all that jazz.

OK, so the onboard NIC is dead on the PC... I fit a PCI NIC to the PC, get 2 green lights on it and check and test - all is working fine.

2 hours later, 'network cable disconnected.'

WTF.

I know sh*ts bad right now with all that starving bullsh*t and the dust storms and we are running out of french fries and burrito coverings.

Re: What's wrong here?
Reply #1 on: January 28, 2012, 19:44:40 PM
sure the same is alright ?  tried wiggling it ?

could be a bit iffy and when you were moving it over to the laptop you wiggled it a bit and it started working ?


either that or check under your bed for a naughty midget :o

Re: What's wrong here?
Reply #2 on: January 28, 2012, 20:27:07 PM
Also tried a different switch port?

Sounds like cable or switch tbh

    • Tekforums.net - It's new and improved!
  • Offline Clock'd 0Ne

  • Posts: 9,019
  • Administrator
  • Clockedtastic
  • Hero Member
Re: What's wrong here?
Reply #3 on: January 28, 2012, 23:31:05 PM
My money is on cable, maybe the laptop NIC is more forgiving of a dodgy cable?

Re: What's wrong here?
Reply #4 on: January 29, 2012, 10:04:22 AM

either that or check under your bed for a naughty midget :o

This, it's almost certainly this.

more seriously though, I'm with the dodgy cable idea, have you tried another cable?

  • Offline Pete

  • Posts: 5,014
  • Hero Member
Re: What's wrong here?
Reply #5 on: January 29, 2012, 12:41:36 PM
I tried a different patch lead. I'm going back down with a switch tomorrow to have another look.
I know sh*ts bad right now with all that starving bullsh*t and the dust storms and we are running out of french fries and burrito coverings.

  • Offline Serious

  • Posts: 13,446
  • Global Moderator
  • Hero Member
Re: What's wrong here?
Reply #6 on: January 30, 2012, 22:06:20 PM
I'm going back down with a switch tomorrow to have another look.

If it is a midget give it a good thrashing with that cable... :twisted:

Most likely is a dodgy cable, then a port issue on the hub

Re: What's wrong here?
Reply #7 on: January 30, 2012, 23:02:38 PM
Is it a managed switch?

Do you have port security on?

Are you firing up a VM and then suddenly it dies?

You know what I'm getting at right? There isn't a chance your switch is seeing two macs for a single port and screaming "HOLY BALLS!!!" Then shutting down sure to overzealous port security config?

Sent from my GT-I9000 using Tapatalk

0 Members and 1 Guest are viewing this topic.