Chat > Guides & Projects
Door open timer switch thingymajig
zpyder:
Got a prototype working with an Uno, now sorting out a polished version on a Leonardo Tiny.
Sent from my SM-G998B using Tapatalk
XEntity:
Nice work! The Wemos D1 Mini BTW has stackable proto boards
Here’s an IR setup I built
https://imgur.com/a/4KLUX6H
zpyder:
Installed and working.
Colleagues have already begun feature creeping requests for the next version haha.
Sent from my SM-G998B using Tapatalk
Clock'd 0Ne:
Impressive how quickly you put it together, nice job!
zpyder:
Wasn't as hard as I thought it would be. I've learned a fair bit of VBA for excel I think my job in the last 2 years. Gave me a good enough coding foundation that once I got used to the syntax it was fairly transferable.
And then the electronics... So long as I think of the pins as integers or boolean variables that's not too difficult either.
The hardest bit is soldering and just knowing little tips and tricks like always needing a resistor on an LED etc. I've blown one clone mini Arduino up with a short circuit somewhere (I think) but they're pretty cheap so not too concerned.
Once I finish a Udemy course on it I've got several projects in kind. I want to make an air quality monitor (rotorua is very bad in terms of geothermal sulphur, smoke from wood burning stoves, and pollen) and a small robot to send under our house to try and figure out where the ants are coming in. I can crawl under there but it's super creepy and a squeeze!
Sent from my SM-G998B using Tapatalk
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version