Ok, got a new challenge that I think I might be able to do but rather than spend hours learning that its not possible I thought I would ask
At present I connect to the main office using a XP Pro initiaited PPTP VPN connection. I setup a linux box that sits in the office (behind a netgear router) that hosts incoming VPN connections. The linux box does its job and even supports proxy/forwarding netBIOS traffic which is perfect.
Unfortunately the hardware of the Linux box is starting to fail and I was wondering whether I could replace the PC with a Cisco router that I have sitting around ?
I am using a 26xx to connect the internet and I have a spare 26xx that was going to the dump. Would it be possible to configure the spare to sit at the main site and service incoming VPN connections ?
Could I then configure my 26xx rather than my PC to establish the tunnel ?
Would I be able to route netBios/broadcasts between the two network segements ?
My ideal solution is to use the two routers as end-points so that both my LAN and the office LAN are fully browsable from either side of the network.
Do you need more information ?
edit: Looks like I need a different IOS to do VPN (c2600-ik9o3s3-mz), so I might have to go begging again :whoops: