Or would I be safer off cutting a nick in the pipe and bending it then welding over?
Apologies for the very poor images - theyre from my work Nokia E51 which has a sh*te camera
(http://www.mark-chapman.com/uploads/one.jpg)
(http://www.mark-chapman.com/uploads/two.jpg)
Here is the new and improved BMIC piping (Got rid of the sh*tty bendy pipe)
(http://www.mark-chapman.com/uploads/three.jpg)
Nuts air plumbing!
ahh, thats fine... job done.... BUT
only 1 fan ?
1 fan ?
you can never have too many fans and theres plenty of room for 2 there ;) ;)
The other one burned out! Because it wasnt a genuine SPAL
I only need one at present until the hot weather - I have it set to come on when the IAT is higher than 40 degrees - and it only ever comes on in traffic
It is surprisingly efficient that intercooler - and its location gets very good airflow
getting tense now - 4 days to go until I find out if my clutch will hold things together !!
If it all goes good, Im over to hamsterley in it in may so those close to the north east prepare for a run !
What clutch have you dropped in it?
Ill drag myself up north around then I think :)
Its only a 450 lb/ft 6 puk clutch which is bound to slip in 1st with the way this turbo spools
Im going to change it for a triple plate 500 lb/ft unit when I get it mapped if it all goes to plan
Some great roads up by her parents place in Hamsterley that Im looking forward to driving on
Want good roads Im sure me and Alan can show you some very intresting roads especially if your willing to go up towards Hexham ;)
yrah, hamsterly is just around the corner... (ish)